Input Shaft Pilot Bearing Replacement (Heavy Duty)

Fig 1: View Of Input Shaft Pilot Bearing, Retaining Ring & Special Tool

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Ensure the bearing is installed squarely into the input shaft bore.
1	Transfer Case Input Shaft Pilot Bearing Retaining Ring NOTE: The pilot bearing retaining ring must be removed and installed before and after the pilot bearing is replaced.
2	Transfer Case Input Shaft Pilot Bearing NOTE: Using a suitable adapter and an arbor press, remove the input shaft pilot bearing by going through the front of the input shaft. Install the bearing using the large side of the DT-48212 bearing installer. Press the bearing until the tool bottoms on the input shaft. Special Tools DT-48212 Input Shaft Pilot Bearing Installer GE-8092 Universal Driver For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Preliminary Procedure
Ensure the bearing is installed squarely into the input shaft bore.

Transfer Case Input Shaft Pilot Bearing Retaining Ring

NOTE:

The pilot bearing retaining ring must be removed and installed before and after the pilot bearing is replaced.

Transfer Case Input Shaft Pilot Bearing

NOTE:

Using a suitable adapter and an arbor press, remove the input shaft pilot bearing by going through the front of the input shaft.
Install the bearing using the large side of the DT-48212 bearing installer.
Press the bearing until the tool bottoms on the input shaft.

Special Tools

For equivalent regional tools, refer to Special Tools .