Master Electrical Schematic Icons
| Icon | Icon Definition |
|---|---|
|
WARNING:
When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs. |
|
|
WARNING:
The connector at the Inflatable Restraint Module cannot be disconnected or removed without damage to the module. If the connector is removed from the module, the entire module with harness must be replaced. |
|
|
WARNING:
The high intensity discharge system produces high voltage and current. To reduce the risk of severe shocks and burns:
|
|
|
NOTE:
The Configurable Provision Relays can be controlled by either the B+ Bus or the Ignition Main Relay Bus depending on the position of the installed fuse that supplies the relays.
Do not install a fuse in both the B+ Bus position and the Ignition Main Relay position at the same time or the relay will not function as intended. |
|
|
NOTE:
Twisted wires provide an effective shield that helps protect sensitive electronic components from electrical interference. In order to prevent electrical interference from degrading the performance of the connected components, you must maintain the proper specification when making any repairs to the twisted wires shown :
|