Rear Side Door Weatherstrip Replacement - Body Side

Preliminary Procedures

1. Remove the upper center pillar trim. Refer to Center Pillar Upper Trim Panel Replacement .
2. Remove the lower center pillar trim. Refer to Center Pillar Lower Trim Panel Replacement .
3. Remove the rear side door sill garnish molding. Refer to Rear Side Door Sill Garnish Molding Replacement .

Procedure

1. Starting in the center bottom of the weatherstrip, pull the weatherstrip upward and away from the pinch-weld flange.
2. Start in the center bottom of the pinch-weld flange.
3. Ensure that the weatherstrip and retainers are fully seated on the flange before installing the front carpet retainer.
4. Inspect the door for proper operation.