Conditions for Setting the DTC

C003A 67 

The yaw rate calculated from the steering angle and the yaw rates calculated from the wheel speed sensors at both axles are compared to a predetermined value. If the calculations do not match the module detects a wrong mounted wheel speed sensor at the front axle.

C0055 67 

The yaw rate calculated from the steering angle and the yaw rates calculated from the wheel speed sensors at both axles are compared to a predetermined value. If the calculations do not match the module detects a wrong mounted wheel speed sensor at the rear axle.

C0035 00, C0040 00, C0045 00, or C0050 00

• A short to ground, or open/high resistance on the wheel speed sensor signal high circuit is detected for 0.2 sec.
• A short to voltage, short to ground, or open/high resistance on the wheel speed sensor signal low circuit is detected for 0.2 sec.

C0035 08, C0040 08, C0045 08, or C0050 08

• A incompatible or wrong wheel speed sensor is installed.

C0035 0F, C0040 0F, C0045 0F, or C0050 0F

• Incorrectly mounted wheel speed sensor.
• Debris on the wheel speed sensor or the tone ring.
• Missing tooth or teeth on the wheel speed sensor tone ring.
• Air gap between the wheel speed sensor and the encoder ring.
• Electrical magnetic interference with the wheel speed sensor harness.

C0035 27, C0040 27, C0045 27, or C0050 27

• Debris on the wheel speed sensor tone ring.
• Missing tooth or teeth on the wheel speed sensor tone ring.
• Air gap between the wheel speed sensor and the encoder ring too large.

C0035 5A, C0040 5A, C0045 5A, or C0050 5A

• An invalid wheel speed sensor signal is detected.
• No wheel speed signal is detected with vehicle speed.
• A difference between the fastest and the slowest wheel speed is greater than 5%.