Driver or Passenger Seat Outer Recliner Finish Cover Replacement (Manual)

WARNING: This page is about a different car, the 2015 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Driver or Passenger Seat Outer Recliner Finish Cover (Manual)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the seat belt from the seat belt anchor. Refer to Driver or Passenger Seat Retractor Side Belt Replacement Remove the front seat belt anchor plate tensioner cover. Refer to Front Seat Belt Anchor Plate Tensioner Cover Replacement Remove the driver or passenger seat recliner lever. Refer to Driver or Passenger Seat Recliner Lever Replacement .
1	Driver or Passenger Seat Outer Recliner Finish Cover Cap
2	Driver or Passenger Seat Outer Recliner Finish Cover Screw (Rear)
3	Driver or Passenger Seat Outer Recliner Finish Cover Screw (Front)
4	Driver or Passenger Seat Outer Recliner Finish Cover Screw (Side)
5	Driver or Passenger Seat Outer Recliner Finish Cover Procedure Disconnect the electrical connector. Disengage and remove the remainder of the finish cover by pulling the cover upward and outboard away from the seat. If replacing the cover, transfer components as necessary.