LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 2.0L (LTG) Or 2.5L (LKW) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Water Pump Removal (LTG)

Water Pump Removal (LTG)

WARNING: This page is about a different car, the 2015 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the thermal bypass hose at the engine oil cooler.
    Fig 1: Thermal Bypass Pipe Bolts And Gasket
    GM2769478Courtesy of GENERAL MOTORS COMPANY
  2. Remove the thermal bypass pipe bolts (1) at the water pump assembly.
  3. Disconnect the pipe from the water outlet assembly.
  4. Remove the thermal bypass pipe (2) and gasket (3) from the water pump assembly. Discard the gasket.
  5. Remove the retaining clip (5) and engine coolant temperature sensor (2).
    Fig 2: Retaining Clip And Engine Coolant Temperature Sensor
    GM2726770Courtesy of GENERAL MOTORS COMPANY
  6. Remove the water outlet assembly (1), bolts (4) and gasket seal (3). Discard the gasket.
  7. Remove the thermostat assembly (2), bolts (3) and gasket seal (4). Discard the gasket.
    Fig 3: Thermostat Assembly And Gasket Seal
    GM2726772Courtesy of GENERAL MOTORS COMPANY
  8. Remove the water pump assembly (5), bolts (1) and seal (6). Discard the seal.
scientia non olet · About LEMON Manuals