Crankshaft Balancer Removal

WARNING: This page is about a different car, the 2015 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

EN-41816 Crankshaft Balancer Remover
EN-41816-2 Crankshaft End Protector
EN-51760 Flywheel Holding Tool

For equivalent regional tools, refer to Special Tools .

To prevent crankshaft rotation, install EN-51760 holding tool (2) and starter motor bolts (1) at the starter motor location and engaging the flywheel.

Fig 1: Starter Motor Bolts
Courtesy of GENERAL MOTORS COMPANY
Remove and discard the crankshaft balancer bolt (1) and washer.

Fig 2: Crankshaft Balancer
Courtesy of GENERAL MOTORS COMPANY
Install EN-41816-2 protector (3) to protect the crankshaft end during balancer removal.
Using EN-41816 remover (4), remove the balancer (2).
NOTE: EN-51577-1 remover (5) can be used alternatively for EN-41816 remover (4).
Remove the special tools.