Camshaft Cover - Top

WARNING: This page is about a different car, the 2015 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Camshaft Cover -- Top

GM3962787

Courtesy of GENERAL MOTORS COMPANY

Camshaft Cover - Top

Callout	Component Name
Preliminary Procedures Thoroughly clean the camshaft cover and mating surfaces. Inspect each component, O-rings, and fasteners, and replace as necessary. Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
1	Engine Coolant Air Bleed Hose
2	Engine Coolant Air Bleed Pipe
3	Engine Coolant Air Bleed Pipe O-Ring
4	Camshaft Cover
5	Camshaft Position Actuator Control Solenoid Valve - Intake
6	PCV Valves and PCV Tube Assembly NOTE: These components have tamper-proof connections and cannot be disassembled.
7	Camshaft Cover Plug CAUTION: Refer to Fastener Caution . Tighten 35 N.m (26 lb ft)
8	Vacuum Pump Seal Special Tools DT 45866 Input Shaft Seal Installer For equivalent regional tools, refer to Special Tools .
9	Ignition Coil
10	Camshaft Position Actuator Control Solenoid Valve - Exhaust