LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Mechanical - 2.0L (LTG) Or 2.5L (LKW) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Oil Level Indicator Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine oil level sensor (1).
    Fig 1: O-ring Around Level Sensor
    GM2812246Courtesy of GENERAL MOTORS COMPANY
  2. Install the engine oil level sensor fastener (1) and tight to 10 N.m (89 lb in).
    Fig 2: Engine Oil Level Sensor Fasteners
    GM2812245Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .
  3. Install the engine oil level sensor C-clip (1).
    Fig 3: Engine Oil Level Sensor C-clip
    GM2812244Courtesy of GENERAL MOTORS COMPANY
  4. Connect the oil level sensor electrical connector.
  5. Install the lower oil pan. Refer to Lower Oil Pan Replacement .
scientia non olet · About LEMON Manuals