LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Mechanical - 2.0L (LTG) Or 2.5L (LKW) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement (North America) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the crankshaft balancer with NEW fastener. Use EN-51577-1  Crankshaft Balancer Remover (1) and breaker bar (2) prevent the crankshaft from rotating while tightening the NEW crankshaft balancer fastener (3).
    Fig 1: Crankshaft Balancer Remover
    GM3971349Courtesy of GENERAL MOTORS COMPANY
  2. Tighten the crankshaft balancer bolt to 150 N.m (111 lb ft) plus an additional 140 degrees using the EN-45059  meter.
    CAUTION: Refer to Fastener Caution .
  3. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals