LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Mechanical - 2.0L (LTG) Or 2.5L (LKW) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Balancer Shaft with Oil Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the oil pump. Refer to Balancer Shaft with Oil Pump Assemble
  2. Balancer Shaft with Oil Pump (2)»Install
    Fig 1: Balancer Shaft with Oil Pump
    GM4176256Courtesy of GENERAL MOTORS COMPANY
  3. Balancer Shaft with Oil Pump Bolt (1)»Loosely install [8x]
  4. Balancer Shaft with Oil Pump Bolt»Tighten in sequence [8x]
    Fig 2: Balancer Shaft With Oil Pump Bolt Tightening Sequence
    GM4176261Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .

    Tighten

    1. First pass  58 N.m (43 lb ft)
    2. Final pass  58 N.m (43 lb ft)
  5. Timing Chain Crankshaft Sprocket Replacement »Install
  6. Oil Pan Replacement »Install
scientia non olet · About LEMON Manuals