LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Mechanical - 2.0L (LTG) Or 2.5L (LKW) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Flex Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the automatic transmission flex plate (2) and hand start NEW bolts (1).
    Fig 1: Automatic Flex Plate Attaching Bolts
    GM2726718Courtesy of GENERAL MOTORS COMPANY
    NOTE: Fasteners have adhesive patch and must be tightened to final torque within 5 minutes.
  2. To prevent crankshaft rotation, install EN-50792  holding tool (2) and starter motor bolts (1) at the starter motor location and engaging the flex plate.
    Fig 2: Starter Motor Bolts
    GM2744964Courtesy of GENERAL MOTORS COMPANY
  3. Tighten the bolts evenly using the following procedure:
    Fig 3: Flex Plate Bolt Tightening Sequence
    GM2744962Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .
    1. Tighten the bolts a first pass in sequence to 20 N.m (15 lb ft).
    2. Tighten the bolts a second pass in sequence to 30 N.m (22 lb ft).
    3. Tighten the bolts a final pass in sequence 40 degrees using the EN 45059  meter.
  4. Remove the EN-50792  holding tool.
  5. Install the transmission. Refer to Transmission Replacement .
scientia non olet · About LEMON Manuals