LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Malibu LS >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 1.5L (LFV) - Repair Instructions >> Repair Instructions >> Fuel Injector Wiring Harness Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Fuel Injector
    GM3982080Courtesy of GENERAL MOTORS COMPANY
  1. Connect Electrical Connector (2) at Fuel Injector (3)
  2. Install a NEW cable tie (1) to the position where it was removed
    3. Fig 2: Fuel Injector Wiring Harness
    GM3982086Courtesy of GENERAL MOTORS COMPANY
  3. Connect the fuel injection fuel rail fuel pressure sensor wiring harness plug (1).
  4. Clip the fuel injector wiring harness (3) to the fuel rail.
  5. Install a NEW cable tie (2) to the position where it was removed.
  6. Install Fuel Injection Fuel Rail Assembly Replacement 
scientia non olet · About LEMON Manuals