Front Bumper Fascia Replacement

Fig 1: Front Bumper Fascia

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Front Wheelhouse Liner Replacement Front Bumper Fascia Upper Molding Replacement Underbody Front Air Deflector Replacement
1	Front Bumper Fascia Center Support Bolt - Fascia (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
2	Front Bumper Fascia Upper Guide Bolt (Qty: 2) Tighten 4 N.m (35 lb in)
3	Front Bumper Fascia Bolt (Qty: 2) Tighten 2.5 N.m (22 lb in)
4	Front Bumper Fascia Procedure Carefully push a small nylon wedge between the fascia and the front fascia guide.Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the front fascia guide. Disconnect the electrical connectors. Transfer components as necessary.