Circuit/System Verification

Ignition» On / Vehicle» In Service Mode
Verify the component activates:Radio Speaker The balance and fade controls can be used to help isolate an inoperative speaker or poor sound condition.
- If the component does not activate
  Refer to Speaker Malfunction (without UQA) and Speaker Malfunction (UQA) .
- If all components operate
B153D Seat Belt Buckle - Driver & B153P Seat Belt Buckle - Passenger» Buckled
Verify the scan tool parameter: Driver Seat Belt Status & Passenger Seat Belt Status=Buckled
- If not the specified state
  Refer to Seat Belt Indicator Malfunction - Driver .
- If the specified state
Headlamp Switch» Off
Verify the scan tool parameter: Headlamps On Switch= Inactive
- If not the specified state
  Refer to Headlamps Malfunction
- If the specified state
Park Lamps Switch» Off
Verify the scan tool parameter: Park Lamps Switch= Inactive
- If not the specified state
  Refer to Park, License and/or Tail Lamps Malfunction
- If the specified state
Turn Signal Switch» Off
Verify the scan tool parameter: Left Turn Signal Switch & Right Turn Signal Switch=Inactive
- If not the specified state
  Refer to: Park, License and/or Tail Lamps Malfunction
- If the specified state
Park Brake»Off
Verify the scan tool parameter: Park Brake Switch=Inactive
- If not the specified state
  Refer to Park Brake System Diagnosis
- If the specified state
Close the doors and verify that the luggage compartment is empty.
Verify the scan tool parameter: Driver Door Ajar Switch & Passenger Door Ajar Switch & Left Rear Door Ajar Switch & Right Rear Door Ajar Switch=Inactive
- If not the specified state
  Refer to Door Ajar Indicator Malfunction
- If the specified state
All OK.