Windshield Wiper Arm Replacement

Fig 1: Windshield Wiper Arm

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Windshield Wiper Arm Finish Cap Procedure Use a flat bladed plastic tool to remove.
2	Windshield Wiper Arm Fastener CAUTION: Refer to Fastener Caution . Tighten 23 N.m (17 lb ft)
3	Windshield Wiper Arm Procedure Set the windshield wiper arms in the park position. Insert the windshield wiper arm end over the windshield wiper motor pivot shaft. Hold the windshield wiper arm in position while torquing the wiper arm fastener. Align the windshield wiper blade tip to the alignment mark in the lower windshield blackout. Refer to Windshield Wiper Arm Adjustment Inspect the windshield wiper operation. NOTE: Use the BO-6626 puller if the windshield wiper arm fails to release from the wiper motor pivot shaft. Special Tools BO-6626 Wiper Arm Puller Equivalent regional tools:Special Tools .

Callout

Component Name

Windshield Wiper Arm Finish Cap
Procedure
Use a flat bladed plastic tool to remove.

Windshield Wiper Arm Fastener

CAUTION: Refer to Fastener Caution .

Tighten
23 N.m (17 lb ft)

Windshield Wiper Arm

Procedure

Set the windshield wiper arms in the park position.
Insert the windshield wiper arm end over the windshield wiper motor pivot shaft.
Hold the windshield wiper arm in position while torquing the wiper arm fastener.
Align the windshield wiper blade tip to the alignment mark in the lower windshield blackout. Refer to Windshield Wiper Arm Adjustment
Inspect the windshield wiper operation.

NOTE: Use the BO-6626 puller if the windshield wiper arm fails to release from the wiper motor pivot shaft.

Special Tools
BO-6626 Wiper Arm Puller
Equivalent regional tools:Special Tools .