Ignition and Start Switch Replacement (Without BTM)

Fig 1: Ignition and Start Switch

GM3271146

Courtesy of GENERAL MOTORS COMPANY

Callout

Component Name

Preliminary Procedure
Theft Deterrent Module Replacement (Chevrolet / GMC)Theft Deterrent Module Replacement (Cadillac)

1

Ignition and Start Switch

Procedure

Disconnect the electrical connector.
Remove the Passlock and key buzzer from the ignition lock cylinder case.
Use the EL-42759 release tool to release the plastic retaining tabs on the ignition and start switch.
Pull the ignition and start switch out of the ignition lock cylinder case.

Special Tools
EL-42759 Ignition Switch Connector Release Tool
Equivalent regional tools:Special Tools