Rocker Panel Molding Replacement

Fig 1: Rocker Panel Molding

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the wheel and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
1	Rocker Panel Molding Screw (Qty: 5) CAUTION: Refer to Fastener Caution . Tighten 1.5 N.m (13 lb in)
2	Rear Wheelhouse Extension
3	Rocker Panel Molding Retaining Clip (Qty: 6)
4	Rocker Panel Molding
5	Front Rocker Panel Molding Protect Film NOTE: When installing new parts, attach the protect film to molding.
6	Front Rocker Panel Molding Inside Clip (Qty: 9)
7	Front Rocker Panel Molding Double-Sided Adhesive Tape (Qty: 3) NOTE: When installing new parts, attach the double-sided adhesive tape to molding.