Rear Side Door Replacement

Fig 1: Rear Side Door

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to SIR Warning . Preliminary Procedures Mark the location of the hinge before removing the bolts with a grease pencil. Remove the rear door trim panel. Refer to Rear Side Door Trim Replacement .
1	Rear Side Door Check Link Bolt to Body CAUTION: Refer to Fastener Caution . Procedure Remove the water deflector. Disconnect the door electrical connector. Support the door before removing the hinge bolts. With an assistant, remove the door. After the door has been removed, ensure that the dome lamp is off. If the dome lamp is on remove the fuse. Tighten 22 N.m (16 lb ft)
2	Rear Side Door Lower Hinge Bolt to Door (Qty: 2) Tighten 25 N.m (18 lb ft)
3	Rear Side Door Upper Hinge Bolt to Door (Qty: 2) Tighten 25 N.m (18 lb ft)
4	Rear Side Door Assembly Procedure When replacing the door it is necessary to transfer all of the internal components. If the door striker needs adjust. Refer to Rear Side Door Lock Striker Adjustment . Rear door adjustment. Refer to Rear Side Door Adjustment .