Front Bumper Fascia Replacement

Fig 1: Front Bumper Fascia

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the front wheelhouse liner screws to the fascia. Refer to Front Wheelhouse Liner Replacement .
1	Front Bumper Fascia Upper Bolt (Qty 2) CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
2	Front Bumper Fascia Lower Bolts (Qty: 4) Tighten 17 N.m (13 lb ft)
3	Front Bumper Fascia Procedure Carefully push a small nylon wedge between the fascia and the front fascia guide. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the front fascia guide. Disconnect any electrical connectors. Transfer components as necessary.