LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Malibu LS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.0L (LTG) Or 2.5L (LKW) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Powertrain Mount Balancing - Lower

Powertrain Mount Balancing - Lower

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    Fig 1: Front Transaxle Mount Through Bolt
    GM2813614Courtesy of GENERAL MOTORS COMPANY
    NOTE: Follow the balance procedure steps listed below. Powertrain mounts must be tightened in sequence.
  2. Loosen the front transaxle mount through bolt.
  3. Loosen the rear transaxle mount through bolt.
    Fig 2: Rear Transaxle Mount Through Bolt
    GM2813620Courtesy of GENERAL MOTORS COMPANY
  4. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
  5. Tighten the rear transaxle mount through bolt to 100 N.m (74 lb ft).
    CAUTION: Refer to Fastener Caution .
  6. Tighten the front transaxle mount through bolt to 100 N.m (74 lb ft).
    Fig 3: Front Transaxle Mount Through Bolt
    GM2813614Courtesy of GENERAL MOTORS COMPANY
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals