LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Malibu LS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.0L (LTG) Or 2.5L (LKW) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Engine Oil Cooler Replacement >> Installation Procedure

Installation Procedure

  1. Install the engine oil cooler (1).
    Fig 1: Engine Oil Cooler
    GM2874859Courtesy of GENERAL MOTORS COMPANY
    NOTE: A NEW engine oil cooler seal must be used whenever reinstalling the engine oil cooler.
  2. Position the engine oil cooler so that the tab (1) is against the engine block (2).
    Fig 2: Engine Block
    GM4322830Courtesy of GENERAL MOTORS COMPANY
  3. Install the engine oil cooler connector (3) and tighten to 50 N.m (37 lb ft).
    Fig 3: Engine Oil Cooler Connector
    GM2874857Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Component Fastener Tightening Caution .
  4. Install the oil cooler hose (1) and (2).
  5. Install the oil cooler fastener (1) and tighten to 10 N.m (89 lb in)
    CAUTION: Refer to Fastener Caution .
  6. Install the engine oil filter. Refer to Engine Oil and Oil Filter Replacement .
scientia non olet · About LEMON Manuals