LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Malibu LS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.0L (LTG) Or 2.5L (LKW) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement (North America) >> Installation Procedure

Installation Procedure

  1. Install the crankshaft balancer with NEW fastener. Use EN-51577-1  Crankshaft Balancer Remover (1) and breaker bar (2) prevent the crankshaft from rotating while tightening the NEW crankshaft balancer fastener (3).
    Fig 1: Crankshaft Balancer Remover
    GM3971349Courtesy of GENERAL MOTORS COMPANY
  2. Tighten the crankshaft balancer bolt to 150 N.m (111 lb ft) plus an additional 140 degrees using the EN-45059  meter.
    CAUTION: Refer to Fastener Caution .
  3. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals