LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Malibu LS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.0L (LTG) Or 2.5L (LKW) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Automatic Transmission Flex Plate Replacement >> Installation Procedure

Installation Procedure

  1. Install the automatic transmission flex plate (2) and hand start NEW bolts (1).
    Fig 1: Automatic Flex Plate Attaching Bolts
    GM2726718Courtesy of GENERAL MOTORS COMPANY
    NOTE: Fasteners have adhesive patch and must be tightened to final torque within 5 minutes.
  2. To prevent crankshaft rotation, install EN-50792  holding tool (2) and starter motor bolts (1) at the starter motor location and engaging the flex plate.
    Fig 2: Starter Motor Bolts
    GM2744964Courtesy of GENERAL MOTORS COMPANY
  3. Tighten the bolts evenly using the following procedure:
    Fig 3: Flex Plate Bolt Tightening Sequence
    GM2744962Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .
    1. Tighten the bolts a first pass in sequence to 20 N.m (15 lb ft).
    2. Tighten the bolts a second pass in sequence to 30 N.m (22 lb ft).
    3. Tighten the bolts a final pass in sequence 40 degrees using the EN 45059  meter.
  4. Remove the EN-50792  holding tool.
  5. Install the transmission. Refer to Transmission Replacement .
scientia non olet · About LEMON Manuals