Automatic Transmission Flex Plate Removal

Special Tools 

EN-51760  Flywheel Holding Tool

For equivalent regional tools, refer to Special Tools .

1. To prevent crankshaft rotation, install EN-51760  holding tool (2) and starter motor bolts (1) at the starter motor location and engaging the flywheel.
   Fig 1: Starter Motor Bolts

   Courtesy of GENERAL MOTORS COMPANY
2. Remove and discard the flywheel attaching bolts (1).
   Fig 2: Automatic Flex Plate Attaching Bolts

   Courtesy of GENERAL MOTORS COMPANY
3. Remove the flywheel (2).
4. Remove EN 51760  holding tool.