Ignition Lock Cylinder Replacement (Without BTM)

Preliminary Procedures

1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (Without Start/Stop) and Battery Negative Cable Disconnection and Connection (With Start/Stop) .
2. Remove the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement .
3. Remove the ignition lock cylinder bezel. Refer to Ignition Lock Cylinder Bezel Replacement (Without BTM) .

Procedure

1. Turn the ignition lock cylinder to the RUN position.
2. Insert a pick-type tool into the proper hole on the ignition and start switch housing and press the lock tab on the ignition lock cylinder down while turning the cylinder to the START position.
3. Pull the ignition lock cylinder out of the ignition and start switch housing.
4. If installing a new ignition lock cylinder then refer to Lock Cylinder Coding - Ignition .