Driver or Passenger Seat Head Restraint Replacement

Fig 1: View Of Driver Or Passenger Seat Head Restraint (With AHS)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Driver or Passenger Seat Head Restraint Bezel (Qty: 2) Procedure Raise the headrest to gain access to the head restraint bezel. Twist the bezel counter clockwise and push the bezel upward on the head restraint shaft.
2	Driver or Passenger Seat Head Restraint Clip (Qty: 2) Procedure Using a suitable pointed or flat bladed tool, push the metal clip forward while pulling upward on the head restraint.
3	Bowden Cable at Actuator Right Side Procedure To gain access to the actuator cable see the seat back cover replacement procedure. Refer to Driver or Passenger Seat Back Cushion Cover Replacement Disengage the head restraint cable from the head restraint actuator retainers on the right side.
4	Bowden Cable at Actuator Left Side Procedure Disengage the head restraint cable from the head restraint actuator retainers on the left side.
5	Driver or Passenger Seat Head Restraint Procedure Disengage the head restraint cable strap, if equipped. Note the routing of the head restraint cable for installation.