LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Transmission Cooling System >> Repair Instructions >> Transmission Fluid Cooler Pipe Connector Replacement - Radiator (1.8L LUW and LWE) >> Removal Procedure

Removal Procedure

  1. Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement .
  2. Drain the cooling system. Refer to Cooling System Draining and Filling (GE-47716 Fill) and Cooling System Draining and Filling (Static Fill) .
  3. Drain the transmission fluid. Refer to Transmission Fluid Drain and Fill .
  4. Remove the transmission oil cooler hoses from the oil cooler fittings on the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection (6T30-MH9 and 6T40-MH8)  and Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection (AF40-MDK) .
  5. Remove the oil cooler fitting (1) and the O-ring (2) from the radiator.
    Fig 1: Automatic Transmission Oil Cooler Fitting
    GM2027429Courtesy of GENERAL MOTORS COMPANY
    NOTE: Do not remove the upper and lower transmission oil cooler fittings from the radiator at the same time otherwise the transmission oil cooler will fall inside the radiator end tank.
scientia non olet · About LEMON Manuals