LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Transmission Cooling System >> Repair Instructions >> Transmission Fluid Cooler Inlet and Outlet Pipe Replacement >> Installation Procedure

Installation Procedure

  1. Install the transmission fluid cooler inlet and outlet pipe to the vehicle.
    Fig 1: Inlet Pipe And Transmission Housing Clip
    GM3288747Courtesy of GENERAL MOTORS COMPANY
  2. Remove the plug and/or caps from the pipe and transmission.
  3. Install the nut (4) to the transmission fluid cooler inlet pipe fitting bolt (1) and tighten to 22 N.m (16 lb ft). Use NEW O-ring (2).
    CAUTION: Refer to Fastener Caution .
  4. Raise the vehicle.
  5. Install the nut (6) to the transmission fluid cooler outlet pipe fitting bolt (7) and tighten to 22 N.m (16 lb ft). Use NEW O-ring (8).
  6. Connect the 2 plastic clips (2) to the quick connect fittings of transmission fluid cooler inlet and outlet pipe (1). Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection (6T30-MH9 and 6T40-MH8)  and Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection (AF40-MDK) .
    Fig 2: Plastic Clips And Outlet Pipe
    GM3288746Courtesy of GENERAL MOTORS COMPANY
  7. Install the transmission fluid cooler outlet pipe to the clip to the fan shroud clip (4).
  8. Install the battery tray. Battery Tray Replacement .
  9. Install the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  10. Check and correct the transmission fluid level. Refer to Transmission Fluid Drain and Fill .
  11. Check for leaks.
scientia non olet · About LEMON Manuals