Transmission Fluid Pump, Front Differential Carrier Baffle and Front Differential Ring Gear Installation (6T30)

Fig 1: Transmission Fluid Pump, Front Differential Carrier Baffle And Front Differential Ring Gear

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Torque Converter and Differential Housing Seal
2	Fluid Pump Assembly
3	Fluid Pump Bolts M8 x 33 (Qty: 7) CAUTION: Refer to Fastener Caution . Tighten  10 N.m (89 lb in) then rotate the bolt an additional 45 degrees Special Tool  EN-45059  Angle Meter or equivalent For equivalent regional tools, refer to Special Tools .
4	Front Differential Carrier Bearing Assembly
5	Front Differential Ring Gear
6	Front Differential Ring Gear Retainer NOTE: Install the retainer with the taper facing away from the ring gear.
7	Front Differential Carrier Baffle
8	Front Differential Carrier Baffle Bolts M6 x 25 (Qty: 2) Tighten  12 N.m (106.21 lb in)