Circuit/System Verification

Ignition ON.
WARNING: Refer to Parking Brake and Drive Wheels Warning .

NOTE: If other DTCs are set, diagnose those DTCs first.
Verify DTC P0716, P0717, P0722, P0723, P077C, P077D, P07BF or P07C0 was not set by reviewing the scan tool Freeze Frame/Failure Records data.
- If any of the DTCs were set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If none of the DTCs were set
Engine idling, transmission in Park, with parking brake applied and drive wheels chocked.
Verify the transmission fluid level and condition is correct. Refer to Transmission Fluid Level and Condition Check .
- If the transmission fluid level and condition is not correct
  Repair as necessary.
- If the transmission fluid level and condition is correct
Ignition ON, clear the TCM DTCs with a scan tool.
Verify DTC P2714 or P2715 does not set while performing a road test. Refer to Road Test .
- If DTC P2714 or P2715 sets
  Refer to Circuit/System Testing .
- If DTC P2714 or P2715 does not set
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing .
- If the DTC does not set
All OK.