Circuit/System Verification
- Engine idling, transmission in Park, with service brake applied. Move the S3 Transmission Shift Lever into each gear position for 2-3 s and back into the Park position.WARNING: Refer to Parking Brake and Drive Wheels Warning .
- Verify the scan tool parameters listed below do not display Malfunction:
- Line Pressure Control Solenoid Valve Performance Test Status
- Line Pressure Control Solenoid Valve Control Circuit Low Voltage Test Status
- Line Pressure Control Solenoid Valve Control Circuit High Voltage Test Status
- If Malfunction is displayed
Refer to Circuit/System Testing .
- If Malfunction is not displayed
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing .
- If the DTC does not set
- If the DTC sets
- All OK.