Conditions for Running the DTC
P0796
- DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0716, P0717, P0722, P0723 or P182E is not set.
- Engine speed is 400-7, 500 RPM for 5 s.
- Transmission output speed is 100 RPM or greater or the throttle position is 0.5% or greater.
- Ignition voltage is 9-32 V.
- Transmission fluid temperature is -6.7°C (20°F) or greater.
- High side driver is enabled.
- Throttle position signal is valid.
P0797
- DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0716, P0717, P0722, P0723 or P182E is not set.
- Engine speed is 400-7, 500 RPM for 5 s.
- Transmission output speed is 100 RPM or greater or the throttle position is 0.5% or greater.
- Throttle position signal is valid.
- Ignition voltage is 9-32 V.
- Transmission fluid temperature is -6.7°C (20°F) or greater.
- High side driver is enabled.
- The throttle position is 10% or greater and the engine torque is 45 N.m (33 lb ft) or greater if attained gear is 1st free wheel.
- DTC runs continuously during shift when the 4-5-6 clutch is commanded OFF, until commanded range is attained.