Conditions for Running the DTC
P0776
- DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0716, P0717, P0722, P0723 or P182E is not set.
- Engine speed is 400-7, 500 RPM for 5 s.
- Ignition voltage is 9-32 V.
- Transmission fluid temperature is -6.7°C (20°F) or greater.
- Transmission output speed is 100 RPM or greater or the throttle position is 0.5% or greater.
- Throttle position signal is valid.
- High side driver is enabled.
- Commanded range is reverse, 3rd gear or 5th gear.
- DTC runs continuously when the above conditions are met.
P0777
- DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0716, P0717, P0722, P0723 or P182E is not set.
- Engine speed is 400-7, 500 RPM for 5 s.
- Ignition voltage is 9-32 V.
- Transmission fluid temperature is -6.7°C (20°F) or greater.
- Transmission output shaft speed is 100 RPM or greater or the throttle position is 0.5% or greater.
- Throttle position signal is valid.
- High side driver is enabled.
- Throttle position is 10% or greater and the engine torque is 45 N.m (33 lb ft) or greater.
- DTC runs continuously during shift when the 3-5-R clutch is commanded OFF, until commanded range is attained.