Circuit/System Verification
- Ignition ON.
- Verify the scan tool ISS/OSS Supply Voltage parameter displays OK.
- If OK is not displayed
Refer to Circuit/System Testing .
- If OK is displayed
- If OK is not displayed
- Engine idling, transmission in Park.
- Verify the scan tool Transmission ISS parameter changes without spikes or dropouts, while varying the engine speed.
- If the Transmission ISS does not change with engine speed or has spikes or dropouts
Refer to Circuit/System Testing .
- If the Transmission ISS changes with engine speed and there are no spikes or dropouts
- If the Transmission ISS does not change with engine speed or has spikes or dropouts
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing .
- If the DTC does not set
- If the DTC sets
- All OK.