Conditions for Running the DTC

P0711

• DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0658, P0668, P0669, P06AD, P06AE, P0711, P0712, P0713, P0716, P0717, P0722, P0723, P0962, P0963, P0966, P0967, P0970, P0971, P215C, P2720, P2721, P2729 or P2730 is not set.
• Engine speed is 400-7, 500 RPM for 5 s.
• Ignition voltage is 9-32 V.
• Accelerator position signal is valid.
• Engine torque signal is valid.
• Brake torque is not active.
• DTC runs continuously when above conditions are met.

P0712

• DTC P0712, P0716, P0717, P0722 or P0723 is not set.
• Engine speed is 400-7, 500 RPM for 5 s.
• Ignition voltage is 9-32 V.
• DTC runs continuously when above conditions are met.

P0713

• DTC P0713, P0716, P0717, P0722 or P0723 is not set.
• Engine speed is 400-7, 500 RPM for 5 s.
• Ignition voltage is 9-32 V.
• DTC runs continuously when above conditions are met.