Circuit/System Verification

Engine Running and the gear selector lever in the Park position.
Verify the scan tool High Side Driver 1 parameter displays On.
- If On is not displayed
  Refer to Circuit/System Testing .
- If On is displayed
Verify the scan tool parameters listed below do not display Malfunction:
- High Side Driver 1 Circuit Low Voltage Test Status
- High Side Driver 1 Circuit Open Test Status
- High Side Driver 1 Circuit High Voltage Test Status
- If Malfunction is displayed
  Refer to Circuit/System Testing .
- If Malfunction is not displayed
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing .
- If the DTC does not set
All OK.