LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6T30 (MH9) Or 6T40 (MH8) - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC P0601, P0603, P0604 or P062F: Control Module >> Circuit/System Verification

Circuit/System Verification

  1. Ignition OFF and all vehicle systems OFF. It may take up to 2 min for all vehicle systems to power down.
    CAUTION:

    Before programming a control module, the following must be observed or control module damage may occur:

    • The TIS terminal, MDI and/or scan tool must have the latest software.
    • The vehicle battery must be fully charged. The battery voltage should be between 12-14 volts.
    • The TIS terminal, MDI and/or scan tool connections must be secure.
    • A battery charger must NOT be connected to the battery when programming a control module.
  2. Ignition ON.
  3. Verify that DTC P0601, P0603, P0604 or P062F is not set.
    • If any of the DTCs are set 

      Replace the Q8 Control Solenoid Valve Assembly.

    • If none of the DTCs are set 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  5. Verify the DTC does not set.
    • If the DTC sets 

      Replace the Q8 Control Solenoid Valve Assembly.

    • If the DTC does not set 
  6. All OK.
scientia non olet · About LEMON Manuals