| Torque Converter (28) |
Inspect for damage |
| Case Assembly (50) |
- Inspect for cracked or broken Case (50)
- Inspect for porosity or damage on the sealing surfaces
- Inspect for loose Oil Cooler Line Bolts or damaged Oil Cooler Line Seals
- Inspect for damaged Manual Shift Shaft Seal (604)
- Inspect for damaged or worn Axle Seal (65) or Axle Seal Slinger on the axle shafts
- Inspect for plugged Vent Cap (52)
- Inspect for loose Pressure Test Plug (51), Drain Plug (64) and Fluid Level Plug (63)
- Inspect for damaged Park Pawl Actuator Guide Seal (605)
- Inspect for damaged or worn Input Speed Sensor Seals (19)
|
| Torque Converter Housing Assembly (208) |
- Inspect for damaged Torque Converter Housing Assembly (208)
- Inspect for porosity or damage on the sealing surfaces
- Inspect for damaged Torque Converter Housing Seal (23)
- Inspect for damaged or worn Torque Converter Fluid Seal (301)
- Inspect for loose Torque Converter and Differential Housing Bolts (26)
- Inspect for damaged or worn Axle Seal (209) or Axle Seal Slingers on the axle shafts
- Inspect for loose, missing or damaged Fluid Fill Tube Plug Assembly (27)
- Inspect for damaged Torque Converter and Differential Housing Seal (202)
|
| Valve Body Cover Assembly (2) |
- Inpsect for damaged or warped Valve Body Cover Assembly (2)
- Inspect for damaged or improperly installed Valve Body Cover Gasket (3)
- Inspect for loose Valve Body Cover Bolts (1)
- Inspect for damaged or improperly installed Wire Connector Hole Seal (5)
|