Fastener Specifications

Application	Specification
Application	Metric	English
Control Arm to Steering Knuckle Bolt and Nut
First Pass	50 N.m (1)	37 lb ft (1)
Second Pass: Loosen the Nut	120 Degrees
Third Pass	50 N.m	37 lb ft
Final Pass	35 Degrees
Control Arm to Subframe Bolt - Front
First Pass	70 N.m (1)	52 lb ft (1)
Final Pass	75 - 90 Degrees
Control Arm to Subframe Bolt - Rear
First Pass	70 N.m (1)	52 lb ft (1)
Final Pass	75 - 90 Degrees
Front Bearing to Steering Knuckle Bolt
First Pass	100 N.m	74 lb ft
Final Pass	20 - 35 Degrees
Front Stabilizer Shaft Insulator Clamp Bolt
First Pass	22 N.m (1)	16 lb ft (1)
Final Pass	30 Degrees
Front Suspension Strut Lower Bolt and Nut
First Pass	90 N.m (1)	66 lb ft (1)
Final Pass	60 Degrees
Front Suspension Strut Mount Nut	65 N.m	48 lb ft
Front Suspension Support Bolt
First Pass	60 N.m (1)	45 lb ft (1)
Final Pass	35 Degrees
Rear Control Arm Bushing to Control Arm
First Pass	55 N.m (1)	41 lb ft (1)
Final Pass	60 Degrees
Stabilizer Shaft Link to Strut Nut	65 N.m (1)	48 lb ft (1)
Steering Gear Outer Tie Rod to Steering Knuckle Nut	35 N.m	26 lb ft
Steering Knuckle to Strut
First Pass	90 N.m (1)	66 lb ft(1)
Final Pass	60-75 Degrees
Strut Shaft Nut	70 N.m	52 lb ft
(1) Use NEW Fastener