LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Front Wheel Bearing and Hub Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the brake rotor. Refer to Front Brake Rotor Replacement (15 inch Brake System J67 and J93) and Front Brake Rotor Replacement (16 inch Brake System J60) .
  3. Remove the wheel speed sensor screw (2).
    Fig 1: Wheel Speed Sensor And Wheel Speed Sensor Screw
    GM2028087Courtesy of GENERAL MOTORS COMPANY
  4. Remove the wheel speed sensor (1) from the steering knuckle.
  5. Remove the wheel drive shaft from the front wheel bearing/hub. Refer to Front Wheel Drive Shaft Replacement - Left Side , Front Wheel Drive Shaft Replacement - Right Side (without Intermediate Shaft) and Front Wheel Drive Shaft Replacement - Right Side (with Intermediate Shaft) .
  6. Remove the front wheel bearing/hub bolts (1).
    Fig 2: Identifying Front Wheel Bearing/Hub Bolts
    GM2027764Courtesy of GENERAL MOTORS COMPANY
  7. Remove the front wheel bearing/hub (1) and front brake shield (2) from the steering knuckle.
    Fig 3: Wheel Bearing/Hub, Front Brake Shield And Steering Knuckle
    GM2027685Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals