Passenger Seat Belt Indicator Malfunction

Ignition OFF. Disconnect the harness connector at the P14 passenger air bag disable indicator.
Test for less than 10 Ω between the ground circuit terminal 4 and ground.
- If 10 Ω or greater
  Repair the open/high resistance in the circuit.
- If less than 10 Ω
Ignition ON. With a scan tool, command the Passenger Seat Belt Reminder Indicator OFF.
Test for less than 11 V between the control circuit terminal 6 and ground.
- If 11 V or greater
1. Ignition OFF. Disconnect the X1 harness connector at the K36 inflatable restraint sensing and diagnostic module. Ignition ON.
2. Test for less than 1 V between the control circuit terminal 6 and ground.
  - If 1 V or greater, repair the short to voltage on the circuit.
  - If less than 1 V, replace the K36 inflatable restraint sensing and diagnostic module.
- If less than 11 V
With a scan tool, command the Passenger Seat Belt Reminder Indicator ON.
Test for greater than 4 V between the control circuit terminal 6 and ground.
- If 4 V or less
1. Ignition OFF. Disconnect the X 1 harness connector at the K36 inflatable restraint sensing and diagnostic module.
2. Test for infinite resistance between the control circuit terminal 6 and ground.
  - If less than infinite resistance, repair the short to ground on the circuit.
3. Test for less than 2 Ω between the control circuit terminal 6 and ground.
  - If 2 Ω or greater repair the open/high resistance in the circuit.
  - If less than 2 Ω replace the K36 inflatable restraint sensing and diagnostic module.
- If greater than 4 V
Replace the P14 passenger air bag disable indicator.