Both DTC B0085 and B0088 are set

Ignition OFF. Disconnect the X2 harness connector at the K36 Inflatable Restraint Sensing and Diagnostic Module. It may take up to 2 min for all vehicle systems to power down.
Test for greater than 50k Ω between each signal circuit listed below and ground:
- Left front signal circuit - terminal 19 X2
- Right rear signal circuit - terminal 30 X2
- If 50k Ω or less
1. Ignition OFF. Disconnect the harness connector at the B63 Side Impact Sensor that failed the test. Ignition ON.
2. Test for infinite resistance between the signal circuit and ground.
  - If less than infinite resistance, repair the short to ground on the circuit.
  - If infinite resistance, replace the B63 Side Impact Sensor.
- If greater than 50k Ω
Ignition ON.
Test for less than 1 V between the signal circuit terminals listed below and ground:
- Left front signal circuit - terminal 19 X2
- Right rear signal circuit - terminal 30 X2
- If 1 V or greater
1. Disconnect the harness connector at the B63 Side Impact Sensor that failed the test.
2. Test for less than 1 V between signal circuit and ground.
  - If 1 V or greater, repair the short to voltage in the circuit.
  - If less than 1 V, replace the B63 Side Impact Sensor.
- If less than 1 V
Ignition OFF, reconnect all harness connectors, press in the CPA (if equipped) until an audible and/or tactile click is heard.
Ignition ON, clear DTCs. Operate the vehicle within the Conditions for Running the DTC.
Verify the DTC does not set.
- If the DTC sets
  Replace the K36 Inflatable Restraint Sensing and Diagnostic Module.
- If the DTC does not set
All OK.