LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating, Ventilation And Air Conditioning >> Repair Instructions >> Air Conditioning System Seal Replacement >> Installation Procedure

Installation Procedure

  1. Inspect the new sealing washer for any signs of cracks, cuts or damage.
    NOTE: Flat washer type seals do not require lubrication.

    Do not use a damaged sealing washer.

  2. Remove the cap or tape from the A/C refrigerant components.
  3. Using a lint-free clean, dry cloth, clean the sealing surfaces of the A/C refrigerant components.
    Fig 1: Identifying Proper Seating Of A/C Refrigerant O-Ring
    GM662315Courtesy of GENERAL MOTORS COMPANY
  4. Carefully install the NEW sealing washer (1) onto the A/C refrigerant component.

    The sealing washer (1) must completely bottom against the surface of the fitting.

  5. Assemble the remaining A/C refrigerant components. Refer to the appropriate repair procedure.
    NOTE: After tightening the A/C components, there should be a slight sealing gap of approximately 1.2 mm (3/64 in) between the A/C line and the A/C component.
scientia non olet · About LEMON Manuals