A/C Compressor Solenoid Valve Test
- Ignition OFF, disconnect the harness connector at the Q46 A/C Compressor Solenoid Valve.
- Test for 7-15 Ω between the B+ and control terminal.
- If less than 7 Ω or greater than 15 Ω
Replace the G1 A/C Compressor.
- If between 7-15 Ω
- If less than 7 Ω or greater than 15 Ω
- Test for infinite resistance between each terminal and the Q46 A/C Compressor Solenoid Valve housing/case.
- If less than infinite resistance
Replace the G1 A/C Compressor.
- If infinite resistance
- If less than infinite resistance
- All OK.