LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls And Fuel - 1.8L (LUW, LWE) - Repair Instructions) >> Repair Instructions >> Secondary Air Injection Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the secondary air injection pump (1).
    Fig 1: Secondary Air Injection Pump Pipe
    GM2781588Courtesy of GENERAL MOTORS COMPANY
  2. Loosely install the secondary air injection pump nut (2) and the 2 secondary air injection pump bolts (4).
  3. Tighten the secondary air injection pump nut (2) and the 2 secondary air injection pump bolts (4) to 22 N.m (16 lb ft).
    CAUTION: Refer to Fastener Caution .
  4. Connect the secondary air injection pump pipe (3). Refer to Plastic Collar Quick Connect Fitting Service .
  5. Connect the electrical connector to the secondary air injection pump (1).
  6. Connect the secondary air injection pump inlet hose (1) to the secondary air injection pump (3) and the air cleaner assembly (2). Refer to Plastic Collar Quick Connect Fitting Service .
    Fig 2: Secondary Air Injection Pump Inlet Hose
    GM2834314Courtesy of GENERAL MOTORS COMPANY
  7. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals