LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls And Fuel - 1.8L (LUW, LWE) - Repair Instructions) >> Repair Instructions >> Knock Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Open the hood.
  2. Disconnect the negative cable from the battery. Refer to Battery Negative Cable Disconnection and Connection .
  3. Remove the 2 intake manifold bracket bolts (2, 3).
    Fig 1: Intake Manifold Bracket
    GM2026538Courtesy of GENERAL MOTORS COMPANY
  4. Unclip the wiring harness.
  5. Remove the intake manifold bracket (1).
  6. Remove the sensor bolt (1).
    Fig 2: Knock Sensor And Bracket
    GM2189291Courtesy of GENERAL MOTORS COMPANY
  7. Disconnect the wiring harness plug.
  8. Remove the knock sensor (2) from the bracket (3).
scientia non olet · About LEMON Manuals