LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls And Fuel - 1.8L (LUW, LWE) - Repair Instructions) >> Repair Instructions >> Knock Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the knock sensor (2) to the bracket (3).
    Fig 1: Knock Sensor And Bracket
    GM2189291Courtesy of GENERAL MOTORS COMPANY
  2. Install the sensor bolt (1) and tighten to 20 N.m (15 lb ft).
    CAUTION: Refer to Fastener Caution
  3. Connect the wiring harness plug.
  4. Install the intake manifold bracket (1).
    Fig 2: Intake Manifold Bracket
    GM2026538Courtesy of GENERAL MOTORS COMPANY
  5. Clip in the wiring harness.
  6. Install the 2 intake manifold bracket bolts (2, 3) and tighten to 8 N.m (71 lb in).
  7. Connect the negative cable to the battery. Refer to Battery Negative Cable Disconnection and Connection .
  8. Close the hood.
scientia non olet · About LEMON Manuals