LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls And Fuel - 1.8L (LUW, LWE) - Repair Instructions) >> Repair Instructions >> Ignition Coil Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine wiring harness guide (1) from the cylinder head.
    Fig 1: View Of Engine Wiring Trough And DIS-ignition Module Wiring Harness Plug
    GM1937023Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect the ignition coil plug (2).
  3. Remove the cover of the ignition coil in the direction of the arrow.
    NOTE: Note the arrow on the cover.
  4. Remove the 2 ignition coil bolts.
  5. Install the EN-6009  remover/installer (1).
    Fig 2: Ignition Coil Module And Special Tool
    GM2026537Courtesy of GENERAL MOTORS COMPANY
  6. Remove the ignition coil (2).
  7. Remove the EN-6009  remover/installer (1).
scientia non olet · About LEMON Manuals