LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls And Fuel - 1.8L (LUW, LWE) - Repair Instructions) >> Repair Instructions >> Fuel Tank Replacement >> Assemble Procedure

Assemble Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the fuel tank baffles. Refer to Fuel Tank Baffle Replacement .
  2. Install the evaporative emission canister (1) to the evaporative emission canister bracket.
    Fig 1: Evaporative Emission Canister
    GM2373051Courtesy of GENERAL MOTORS COMPANY
  3. Connect the evaporative emission canister wiring harness plug (3).
  4. Connect the fuel tank vent pipe (2).
  5. Connect the fuel tank pressure sensor electrical connector (1) to the fuel tank pressure sensor (2).
    Fig 2: Fuel Tank Pressure Sensor Electrical Connector
    GM3352067Courtesy of GENERAL MOTORS COMPANY
  6. Install the fuel tank fuel pump module. Refer to Fuel Tank Fuel Pump Module Replacement .
scientia non olet · About LEMON Manuals